I’m hoping to get some help here. I finally took the plunge and installed Bazzite to a spare drive, and during the initial installation setup I was able to connect to my wifi. After booting up for the first time I noticed it said no connection. I see the wifi device listed, but I don’t see anyway to connect. It doesn’t find any networks. I’ve searched around but haven’t found any solutions yet, and I’m hoping someone can point me in the right direction.

I greatly appreciate any help here, and I’m happy to provide any further information if necessary.

  • LeLachs
    40·
    4 months ago

    Check if you have a broadcom adaptor. They have to be enabled manually as they screw with other wifi drivers

      • LeLachs
        40·
        4 months ago

        There is a ujust command for it. You can see the model with lsusb (if it is a stick) or lspci (if it is a card)

  • moncharleskeyOP
    10·
    4 months ago4 months ago

    Okay, so, first off, I really appreciate the comments on this and those that took their time for it. As of now I am connected to my network and everything appears to be working. What’s odd though is I didn’t do anything. I powered it up when I got home, signed in, and had a wifi icon in the bottom right this time, where I found my network and got connected. I had already ran a few shutdown/restarts since installing Bazzite, but apparently this one worked. Now I just have to hope it stays that way. Thanks again!

    Also, this was using the built in Realtek wifi on an Asus B550M motherboard if that helps anyone.